Single-pole and 2-pole configurations available
Stamped and formed contacts available from 6 AWG - 20 AWG
Loose piece, cold-headed contacts available from 6 AWG - 300 MCM
Built-in interlocking dovetails on single-pole housings allow stacking and wire routing
Integral stainless steel locking spring in housing for contact retention
Hermaphroditic/genderless housings reduce inventory
Accessories available for mounting, vibration, protection, and strain relief
Quick connect or disconnect
Replacement for lug connections
For bus bar and backplane power distribution applications
Locking pin feature protects against accidental disconnect
Complete offering of straight and right-angle tabs
Strip and loose piece product available
Compatible with competitive insertion equipment
Tyco Electronics insertion equipment also available
Straight and right-angle shrouded headers with open or closed ends
Double-side female contact design
Built-in interlocks to assemble higher number of ways
Retention latches between plug and header
Vertical and right-angle headers
Connector housings may be stacked end-to-end within one pair of covers
Receptacles available in plain, polarized, latching and guide ribs
0.125 [3.18] centerline
Housing size 8-40 positions
Terminates 26-22 AWG [0.12-0.3mm²] discrete wire as well as jacketed cable and boned ribbon cable (conductors separated)
Double row only
Pre-loaded IDC receptacle contacts
Product Options: Snap-on covers with or without cable tie paddles; stackable end-to-end and side-to-side
Applicable Wire Size: AWG 28-26
DIP-type post headers feature a staggered tine design
Two-row type post headers incorporate two receptacle connectors in a holder
