Pic
|
Specification |
|
|
Series: |
Ballast Products & LED Interconnections
|
|
Features: |
Low Profile, SMT wire poke-in connector
Row-to-row stackable with pads on 4mm centers
Splice poke-in accommodates two (20) pre-stripped 18 AWG solid wires
Connector latches prevent unintentional disconnect of connector
|
|
|
|
|
Series: |
CHAMP 連接器
|
|
Features: |
Industry standard solution
Contacts on 0.8mm, 1.27mm or 2.16mm centerlines
Mounting Methods: Right-angle, edge and vertical
|
|
|
|
|
Series: |
IDC 端子 (MT EI 系列連接器)
|
|
Features: |
Contacts accept discrete wire, ribbon cable, laminated ribbon cable, shield drain wire and jacketed cable
Receptacle housing is preloaded with insulation displacement receptacle contacts |
|
|
|
|
Series: |
MTA 100 連接器
|
|
Features: |
0.100” centerline spacing
2 - 28 position
Terminates 28-22 AWG discrete wire or notched ribbon cable
Closed end and feed-through receptacles with and without polarization tabs
Right-angle and vertical mount headers with friction lock and shroud options
IDC wire-to-board and wire-to-wire connection system
250V, 5A contact rating
Connector housings are polarized to prevent reverse mating
|
|
|
|
|
Series: |
MTA 156 連接器
|
|
Features: |
Connector styles include both closed end and feed-thru, with and without locking ramps and polarizing tabs
Connectors and headers, except shrouded headers, are end-to-end stackable
Molded ribs on housing do not allow reverse mating
|
|
|
|
|
Series: |
MTA-50 IDC 連接器和針座
|
|
Features: |
0.050” staggered centerline spacing
2 - 28 position
Terminates 30-26 AWG discrete wire or ribbon cable
30V, 1.5A contact rating
Closed end and feed-through receptacles
Right angle and vertical mount headers with SMT and through-hole capability
Fully shrouded headers offer polarization and positive detent latching
IDC wire-to-board connector system
|
|
|
|
|
Series: |
MTIS (MT 互聯繫統)
|
|
Features: |
Mass termination of several discrete wires or ribbon cable in a single operation
Contacts with dual leaf cantilever beams
Posts protected on three sides by housing walls
High production rates with no rejects
Crimp snap-in contacts for subsequent wiring changes
Headers are available in vertical or right-angle flat versions with single row or staggered solder tynes
|
|
|
|
|
Series: |
樞軸連接器
|
|
Features: |
Eliminates need for a tool for termination - just use your finger
Small size and tool-less capability make it perfect for space constrained applications
Terminate wires from either side of the connector or pass wires completely through for bridging connections
Perfect for field-installed products; IDC contacts eliminate need to strip wires |
|
|
|
|
Series: |
金屬殼微圓形螺紋耦合連接器
|
|
Features: |
High cycle life spring probe and pad contact interface - 5000+ mating cycles
Threaded coupling mechanism
High density for limited space applications
Multiple shell sizes and keying configurations |
|
|